Check out this amazing project on ArcH2O by Larry Martin studio. Continue reading INVOLUTION | Savannah Georgia [Arch2O.com]
More images of the final fabrication will follow… [Also see the official project page http://cargocollective.com/designfabrication/admin/5499654] Continue reading Plastic Fabric Composite Research [Final Review Presentation]
[More images of the final construction to follow…] Continue reading Sneak Preview….
After further testing I have discovered that for the time being, a hexagonal grid pattern is not a viable solution for this semester’s research with the limited time left. Due to the fact that the plastic is not directly smashed on the the fabric as it was during the 2D panel tests, there is a little bit of drag that is allowed before the plastic hits the suspended fabric—this causes a certain amount of curve smoothing to occur in the the extrusion path. Therefore a diagrid pattern is still the best solutions as it allows the extrusion path to be linear allowing the … Continue reading Updated on Semester Research
Robotic Research Facility at ETH, Zurich 2010. Robotically controlled hot-wire cutting of Styrofoam blocks Continue reading How Technology is Changing Architecture [ReBlog]
This is the first set of prints testing the hexagonal print pattern from the scripts in the previous posts. It is also the first panel print since the robots have been re-installed. As you can see the pattern did not print so well. Future tests will consist of an enlarged hexagonal pattern and a diagrid pattern. Continue reading Hexagonal Pattern Print Test + First Panel Print Test